Drive Of Farming Machines; Work With Pto Shaft; Controlling The Front And Rear Pto Shaft; Display Of Revolutions Of The Pto Shaft - Zetor Forterra CL 100 Operator's Manual

Work with PTO shaft

Before attaching of an implement, driven by means of the tractor PTO shaft, check the speed
compatibility of both, it means tractor PTO shaft and implement driven shaft (540 rpm or 1,000 rpm).
Different PTO speed values may cause serious damages and injuries.
1. When working with PTO shaft mind that all the covers are duly fixed.
2. After completing the work, always mount the cover of PTO shaft back.
3. Any repairs or cleaning of aggregated machines parts driven by PTO shaft to be done only with the
engine at halt and PTO clutch disengaged.
4. Before starting an aggregated machine driven by PTO shaft, make sure that there are no
unauthorized personnel near, there is a risk of injury.

Controlling the front and rear PTO shaft

Switches and controls of front and rear PTO shaft control
are located on the right column of the cabin:
1. The control of the selection of rear PTO shaft
revolutions (P.T.O.)
2. Rear PTO shaft switch
3. Front PTO shaft switch

Display of revolutions of the PTO shaft

When the switches are activated, number of revolutions of
PTO shafts is displayed on the corresponding main screen
of the instrument panel display.
1 - number of revolutions of the front PTO shaft
2 - number of revolutions of the rear PTO shaft at
independent engine speed
Engine speed of the dependent rear PTO shaft are not
displayed, they are presented in tables. The tractor speed
in km/h in chapter Main technical parameters.

DRIVE OF FARMING MACHINES

103
F13BN020
PP15N021