Rear Pto - Dependent And Independent Speed Selection; Rear Pto - Selecting The Pto Speed Of 540 And 1000 Or 540E Rpm; Front Pto - Zetor PROXIMA POWER Z90 2012 Operator's Manual

REAR PTO - DEPENDENT AND
INDEPENDENT SPEED SELECTION
The selection is performed with the lever
(1) with the tractor at standstill.
a - Independent PTO speed (the rpm
value depends on the engine
speed)
n - Neutral position
Use this position to facilitate the
connection of the articulated shaft
of an agricultural machine. The
end piece of the rear PTO can be
rotated freely.
b - Dependent PTO
speed and direction depends on
the engaged gear and position of
the reversing lever).
DRIVE OF AGRICULTURAL MACHINES
G154
REAR PTO - SELECTING THE PTO
SPEED OF 540 AND 1000 OR 540E
RPM
The selection is performed with the lever
(1) with the tractor at standstill.
As standard the tractor is equipped with the
combination of 540 and 1000 rpm of the
PTO; optionally, it can be equipped with the
combination of 540 and 540 rpm of the PTO.
a - 1000 rpm or 540E rpm
b - 540 rpm
Shifting of 540 and 1000 (or
540E) rpm is possible regardless
of the number of splines of the
speed (the
installed end piece. The speed of
the PTO and end piece type
must be selected with regard to
the prescribed speed of the atta-
ched machine.
G153

FRONT PTO

The front PTO is equipped with a fixed
six- or twenty-one-spline end piece and it
has the speed of 540 or 1000 rpm.
The tractor may be optionally equipped
with the front PTO with different turning
directions:
a -
b -
99
in accordance with the turning
direction of the engine (standard)
against the turning direction of
the engine (* option)
E356