Maintenance And Treatment Of Tyres - Zetor Forterra CL 100 Operator's Manual

Maintenance and treatment of tyres

Regularly check the outer surface of tyres and verify whether they are free of defects at the sides and over
the bead and whether the reinforcement is not damaged.
Do not use tyres that show a defect any longer.
Tyre inflation
The basic recommended inflation values are specified in the table. Regularly check the tyre pressure before
driving, when the tyres are cold. To inflate the tyres use the pressure controller (B), which acts as a pressure
equalizer, tyre filling device and safety valve. Remove the rubber cap of the pressure controller and screw
a tyre inflation hose instead. Screw the hose up to the end of the thread to compress the non-return valve. If
there is the maximum pressure in the air reservoir (A), the tyres cannot be inflated. In this case you must first
reduce the pressure with the condensate drain valve located in the bottom part of the air reservoir (A). After
inflating the tyres you must put the rubber cap back on the pressure controller.
Recommended inflation values of the front wheel tyres
Principal working
activity
For field work
For road transport
For work with a front
loader at the
maximum permitted
speed of 8 km/h.
MAINTENANCE INSTRUCTIONS
Inflation (kPa)
Load-bearing capacity
(kg)
Inflation (kPa)
Load-bearing capacity
(kg)
Inflation (kPa)
Load-bearing capacity
(kg)
F_02_122a
Tyredimensions and design
540/65 R24 480/65 R28
130-160 130-160
2410-2725 2150-2430
160-190 160-190
2410-2725 2150-2430
200 200
4105 3680
174
14,9R24 420/70R24
130-160 130-170
1490-1700 1665-1900
130-160 190
1490-1700 1665-1900
200 200
2500 2300