System Of Treatment Of Exhaust Gases - Setting; Instrument Panel - Warning; Replenish Fuel; Add Urea - Zetor Forterra CL 100 Operator's Manual

System of treatment of exhaust gases - setting

The regeneration of the diesel particulate filter in case of increased temperature of exhaust gases is
performed at higher engine load. The system of regeneration of the diesel particulate filter DPF can be
controlled through the menu of the engine setting on the instrument panel. The regeneration can be
controlled in two modes. The mode of automatic regeneration of the diesel particulate filter and inhibition of
regeneration of the DPF filter (for safety reasons only).
Enter the menu of the engine setting by long pressing the button (A) on the instrument panel. The service
menu screen (b) is displayed. To enter the engine setting (c), choose the corresponding tab using the
buttons (B) and (C) and confirm it by longer pressing the button (A). The following items are displayed on the
screen:
1 - Automatic regeneration of the diesel particulate filter - DPF Auto
2 - Inhibition of regeneration of the diesel particulate filter - DPF Inhibit
Note: Setting of individual modes is described in Chapter System of Treatment of Exhaust Gases.

Instrument panel - warning

Replenish fuel

When the fuel signal lamp (orange) is lit up, the prompt to
refill the fuel appears in the display for about 3 seconds. If
the fuel is not refilled, the prompt always appears in the
display when the key is moved from the position ´0´ to the
position ´I´ for about 3 seconds. The fuel signal lamp is
permanently on.

Add urea

When the level of the urea tank content drops, the prompt for the addition of urea and the amount of urea in
the tank in percentage of the tank volume are shortly displayed on the display.
Note: More information in chapter System of Additional
Treatment of Exhaust Gases.
INSTRUMENT PANEL
S15N020
63
F15N012
F15N021