Driving Operation; Before You Start; Non-Permitted Starting; Coolant Heater - Zetor Forterra CL 100 Operator's Manual

Before a drive with the new tractor get to know how to shift gears and try individual positions
of the shifting lever when the engine is stopped.
During normal operation and before you set up, make sure that the technical condition ensures safe
operation of the tractor.

Before you start

Before you start the engine, make sure:
1. that the tractor is properly braked
2. that the main gear shifting lever is in the neutral
position
3. that the reversing lever is in the neutral position
4. that the PTO switches are off.
If the clutch pedal is not pressed - the engine cannot be
started - the starting interlock switch is not actuated.
Note: Before the entire starting we recommend you to
prime the fuel system with some strokes of the manual
feed pump.

Non-permitted starting

It is forbidden to start the tractor by short-
circuiting the starter clamps. Start only from the
driver´s seat. It is necessary to disconnect minus pole
of accumulator and all the shifting levers including
PTO shaft shifting lever to be shifted in neutral
position with any manipulation or repair of the starter.
The starter´s clams are covered with a cap.

*Coolant heater

Coolant heater is mounted on the engine block.
The heater has the output of 1000 W with voltage of 220
V of electric alternate current.

DRIVING OPERATION

DRIVING OPERATION
75
F15N047
F11N013
F11N016