Filling The Engine With Oil; Replacing The Fuel Filter Element; Bleeding The Fuel System - Zetor Forterra CL 100 Operator's Manual

Filling the engine with oil

Pour the prescribed quantity of engine oil into the filling
opening (2), start the engine and let it run for 2 - 3 minutes
at 750 - 800 rpm. After stopping of the engine and level
stabilization use the dipstick (1) to check the oil level and
check the cleaner, drain plug (3) and other joints for leaks.

Replacing the fuel filter element

Replace the filter element after releasing the nut (1) and
unscrewing the bowl (2). During the re-assembly of the
cleaned bowl with the new filter element check proper
seating of the bowl gasket. Bleed the fuel system. During
the cleaning and replacement of the filter elements place
a suitable vessel under the engine to catch dripping fuel.

Bleeding the fuel system

Before bleeding place a suitable container under
the engine to collect dripping fuel from the filter and
injection pump.
1. Prime the fuel system with several strokes of the
manual control of the priming pump (1).
2. Release the screw (2) of the fitting of the fuel inlet to the
filter and let the foam escape.
3. Retighten the screw and repeat the procedure until after
releasing of the screw clear fuel starts to continuously flow
from the filter.
MAINTENANCE INSTRUCTIONS
164
H196
F238
F_02_93a
E707