Control Elements Of Pto Shafts; The Buttons For Activation Of Pto Shafts; Selection Switch Of Rear Pto Clutch Revolutions (P.t.o.) - Zetor FORTERRA HSX 120 Operator's Manual

Control elements of PTO shafts

The buttons for activation of PTO shafts

Turning the PTO shaft on (at min. 1500 rpm) and off is
done by the buttons located on the right pillar of the cabin.
1 - button for rear PTO shaft on / off
2 - button for front PTO shaft on / off
If the engine is switched off and the rear or
front PTO shaft is switched on, the PTO shaft is
switched off after the engine has been restarted.

Selection switch of rear PTO clutch revolutions (P.T.O.)

The rear PTO shaft speed is controlled by the button located on the right pillar of the cab.
The default value is 540 rpm of the rear PTO shaft.
By pressing the bottom of the button with the symbol the speed of 1000 rpm of the PTO shaft is shifted, the
button returns to its original position after release. At 1000 rpm, the symbol on the rear PTO shaft shift button
lights up.
Another keystroke at the bottom of the button shifts the PTO shaft to 540 rpm, and the button returns to its
original position after release. At 540 rpm, the symbol on the rear PTO shaft shift button is not illuminated.
The selected number of revolutions of the rear PTO shaft is displayed on the dashboard display.
After restarting the engine, the PTO shaft revolutions speed returns to the mode in which it was before the
engine was switched off.
Change PTO shaft speed between 540 and 1000 rpm only when the PTO shaft is stopped!
Ensure that the correct PTO shaft speed is set relative to the tool attached!
132
DRIVE OF AGRICULTURAL MACHINERY
FHSX18N004
F18N042