Table of Contents
Advertisement
ADJUSTMENT
Adjustment of the lifting draw-bars of the hitch for a single-axle semi-trailer
- Raise the hydraulic arms to the upper - transport position
with the position control selected and the vibration
compensator off.
- Screw the nuts on the adjustable draw-bars towards the
guiding pipe without any play.
- Tighten the nuts by another 3.5 turns.
- Check whether it is possible to tilt off the supporting
hooks freely.
- By lowering and repeated lifting of the hydraulic arms to
the transport position check whether the engine does not
tend to 'stall' at the idle speed - the relief valve of the
hydraulic pump must not be in operation.
- Then, lower the arms slightly.
F_02_142
Adjusting the bowden cable
It is performed if the carrier with the towing hook is in
contact with the supporting hooks. The Bowden cable
must be tensioned to avoid any play of the control lever in
the cab. Then, the cable is secured against loosening with
a nut.
F_2_132
180
Advertisement
Table of Contents
