Stopping The Tractor - Manual Brake; Stopping The Engine; Leaving The Tractor - Zetor Forterra CL 100 Operator's Manual

Stopping the tractor - manual brake

Stop the tractor slowly under standard conditions. Shortly
before stopping:
1. Depress the clutch pedal.
2. Shift the main gear shifting lever to neutral position.
3. With every stopping, secure the tractor against
spontaneous dead start by manual brake.

Stopping the engine

After the work of tractor when the engine was fully loaded,
it is necessary to secure its cooling.
1. Before stopping the engine, lower the revolutions to 800
- 1000 revolutions per minute and allow it to run for the
time of approximately 5 minutes.
2. Shift the lever of manual throttle to STOP position.
3. The engine stops after turning the key from 'I' position
to '0' position.
Attention! When the engine is switched off, the engine control unit remains active for about 2
minutes because of storage of operation data. During this time the supply of current from the
accumulator must not be interrupted. Do not disconnect the accumulator before this time expires.

Leaving the tractor

Before you leave the tractor with safety cabin, do not
forget remove the key in position '0' from the ignition box
(in positions I and II the key cannot be pulled out).
The tractor shall be secured against
spontaneous moving off:
1. Engine switched off.
st
2. 1 gear engaged.
3. Hand brake applied.
In case that the tractor is standing on a slope, its
wheels shall be wedged.
Lock the cabin.
DRIVING OPERATION DRIVING OPERATION
93
FHSX15N011
FHSX15N012
FH12N077