Adjustment Of Toe-In Of The Wheels Of The Front Driving Axle; Front Drive Axle Fenders - Zetor Forterra CL 100 Operator's Manual

Adjustment of toe-in of the wheels of the front driving axle

Note: Tractors are in standard equipped with hydrostatic device.
Set the wheel symmetrically with longitudinal axis of a tractor.
Measure the distance between rims in the front on horizontal level of wheel axis. Mark the place of
measurement.
Travel forward with a tractor so that the marked places would be on horizontal level of rear wheel axis
(turn by 180°) and remeasure the distance between marked places.
Release locking nuts of ball joint heads (2) of connecting rods of devices in hydraulic cylinder.
Adjust toe-in by turning the pin of ball joint (3). Do the adjusting symmetrically with both joints to keep the
same lock of wheels to both sides (do the measurement on the sides of rims).
Locking nuts of heads of ball joints (2), tighten with a torque of 122 - 136 N. Upper surfaces of heads must
be (1) parallel.

Front drive axle fenders

Front drive axle fenders can come in two designs
A - Fenders with solid consoles where the axis of fenders
turn corresponds with the axis of front wheel turn. Fenders
are on adjustable holders that can be set according to
required tracks and the type of tyres used on the side (by
relocating screws (a) to different openings) and also in
terms of height (by relocating screws (b) to different
openings).
B - Fenders with turnable consoles where the axis of
turning corresponds to the axis of front wheel only
partially. This design enables the setting of greater front
wheels lock. Fenders are on adjustable holders which can
be set according to the kind of tyres used in terms of
height (by relocating screws (b) to different openings).
WHEEL TRACK CHANGE
C507
135
E505