Checking The Oil In Gearbox; Check And Replacement Of Oil In Gear Box; Draining And Checking Holes; After Draining Oil - Zetor Forterra CL 100 Operator's Manual

Checking the oil in gearbox

The height of oil in gear box set is checked by oil level
indicator which is placed at the right rear part of the
gearbox behind the right hydraulic roller.
A - Standard oil filling
Carry out the check always with the engine
stopped.

Check and replacement of oil in gear box

Draining and checking holes

1. drain plug of oil from clutch box
2. drain plug of oil from gearbox
3. drain plug of oil from final drive housing
4. drain plug of oil from final drive housing box
5. drain plug of oil from final house driving box
6. Pouring opening for gear oil is placed in hydraulic
mechanism housing. Accessible from the rear part of the
tractor

After draining oil

1 - clean the magnet (it is part of the lid) and the strainer
element of the suctioning filter (2)
2 - after cleaning screw all the drain screws back on
3 - fill oil, start the engine and let it run for approx.
2 minutes
4 - after stopping of the engine and stabilization of the oil
level in the gearbox check its quantity and fill up oil to the
upper edge of the dipstick tab or if increased filling is
necessary, to the lower or upper mark of the dipstick

Replacement of the transmission oil cleaner element with hydraulic pump suction filter

The oil cleaner is placed on the left side of the gearbox.
Before replacing the oil cleaner element, place
a suitable vessel for dripping oil under the tractor.
1. Unscrew the body of the cleaner (1)
2. Replace the filtration element
3. Reassemble the body of the cleaner
MAINTENANCE INSTRUCTIONS
169
FH12N016
FH12N015
FH12N078
F11N038