Table of Contents
Advertisement
Chapter 2 - Base Station InstallationConnecting the Indoor Equipment
Chapter 2 - Base Station Installation
2.12
Connecting the Indoor Equipment
IMPORTANT
The following instructions are for the AC PoE Injector available from Alvarion. For details on
NOTE!
installing the DC PoE Injector available from Alvarion refer to the Quick Installation Guide supplied
with it.
After mounting the unit with the Ethernet cable connected and verifying proper grounding, proceed to
complete the indoor installation.
To connect the indoor equipment:
1
Insert and crimp a shielded RJ-45 connector to the Ethernet cable. For detailed instructions on how to
prepare the Ethernet cable refer to
2
Connect the Ethernet cable to the OUT connector of the PoE Injector.
3
Use the power cable to connect the PoE Injector to a mains outlet.
4
Use a standard Gigabit Ethernet cable to connect the IN connector of the PoE Injector to the
networking equipment.
WBSn-2400 and WBSn-2450 System Manual
Figure 2-6: AC PoE Injector
"Preparing the Base Station's Ethernet Cable" on page
Connecting the Indoor Equipment
116.
18
Advertisement
Table of Contents
