Alvarion WBSn-2400 System Manual page 72

Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management
The Interfaces page displays the current status of the AVLAN3316 (l2tp), LAN, and WAN networks. It
also displays status parameters for all configured VLANs (if applicable). The network's status parameters
are:
Uptime
MAC Address: The MAC address of the network's interface. Not applicable for the l2tp
(AVLAN3316) network.
Protocol: The method used for setting the IP address (static or dhcp). For the AVLAN3316 interface
the protocol is l2tp.
RX: The accumulated numbers for received Bytes and Packets.
TX: The accumulated numbers for transmitted Bytes and Packets.
IPv4: The IP address and prefix mask.
The icons in parenthesis below the interface name provide indication regarding the Ethernet and
wireless networks associated with the network:
The Ethernet icon (
to any network (In addition to eth0 assigned to either the LAN or the WAN zone, an Ethernet interface
named eth0.<VLAN_ID> is assigned to any configured VLAN).
A wireless network icon (
Hover with the mouse over an icon to open an infotip with the name of the relevant Ethernet/wireless
network it represents.
The following action buttons are available for each interface:
Connect: Click the button to connect a network that is currently disabled.
Stop: Click the button to disable an interface
CAUTION If you stop the network used for managing the device you may loose the ability to manage the device
from remote.
If you stop the AVLAN3316 network you may loose the ability to properly manage the device from the
Arena controller.
Edit: Click the button to switch to the relevant Interface's page.
3.5.1.2 Per Interface Pages
This section includes:
Introduction
Switching from Bridge Mode to Router Mode and Vice Versa
Common Configuration
WBSn-2400 and WBSn-2450 System Manual
) provides a visible indication on the total number of Ethernet interfaces assigned
) is displayed for each wireless network assigned to the network.
Network
62