Alvarion WBSn-2400 System Manual page 40

Chapter 3 - Base Station ManagementStatus
Chapter 3 - Base Station Management
Uptime
MAC Address: The MAC address of the network's interface. Not applicable for the l2tp
(AVLAN3316) network.
Protocol: The method used for setting the IP address (static or dhcp). For the AVLAN3316 interface
the protocol is l2tp.
RX: The accumulated numbers for received Bytes and Packets.
TX: The accumulated numbers for transmitted Bytes and Packets.
IPv4: The IP address and prefix mask.
The icons in parenthesis below the interface name provide indication regarding the Ethernet and
wireless networks associated with the network:
The Ethernet icon (
to any network (In addition to eth0 assigned to either the LAN or the WAN zone, an Ethernet interface
named eth0.<VLAN_ID> is assigned to any configured VLAN).
A wireless network icon (
Hover with the mouse over an icon to open an infotip with the name of the relevant Ethernet/wireless
network it represents.
3.2.1.6 Wireless
A suitable icon on the left side indicates the mode/status of each of the available radio cards:
WBSn-2400 and WBSn-2450 System Manual
) provides a visible indication on the total number of Ethernet interfaces assigned
) is displayed for each wireless network assigned to the network.
Figure 3-10: Status Overview Page, Wireless Section
Status
30