Table of Contents
Advertisement
Appendix A - TroubleshootingUsing the Reset Button of the Base Station
Appendix A - Troubleshooting
NOTE!
It is highly recommended to upload the firmware file to both banks before rebooting the unit, regardless
of the order in which they are loaded.
4
After successful completion of the upload process, click on the Reboot button. After reset the unit
should resume normal operation using the uploaded firmware.
If normal operation is not resumed after uploading a good firmware file, then most probably there is a
configuration problem. Click on the Default Configuration button. After a few minutes the unit
should restart using the factory default configuration.
INFORMATION
Click on the Flash State button if you wish to verify which software files are installed in the base
station.
WBSn-2400 and WBSn-2450 System Manual
Figure A-2: Rescue Mode - Upgrade Progress Screen
Using the Reset Button of the Base Station
114
Advertisement
Table of Contents
