Chapter 3 - Base Station ManagementStatus
Chapter 3 - Base Station Management
For each of the available radio cards the following details for each of the configured wireless networks
(SSIDs) are displayed:
INFORMATION
For more details on Wireless parameters refer to
SSID / Mesh ID: The name (Service Set IDentifier) of the wireless network. Click on the link to open
the relevant Wireless Network configuration page.
Mode: The operation mode of the wireless network.
Channel: Shows the channel number and frequency that the AP is using.
Bitrate: This is the maximum bitrate supported by the radio in the current configuration. Not
applicable for a Mesh-Monitoring wireless network.
MAC-Address: Applicable only for a Mesh-Client wireless network. The MAC address of the
associated device.
BSSID: The Basic Service Set IDentifier. Not applicable for a Mesh-Monitoring wireless network.
Encryption: The wireless encryption mode being used for the wireless network. Not applicable for a
Mesh-Monitoring wireless network.
ACK Timeout: Shows the maximum acknowledgment time in microseconds (derived from the value
configured for the Distance parameter). Not applicable for a Mesh-Monitoring wireless network.
DFS Status: Indicates whether DFS (Dynamic Frequency Selection) is activated to properly support
applicable regulations for the configured Regulatory Domain/Country (applicable only for the 5 GHz
band). When DFS is enabled, the AP automatically switches channel if radar is detected on the current
channel. Not applicable for a Mesh-Monitoring wireless network.
TX-CCQ: The uplink transmission quality in % (a higher percentage means a better wireless
connection quality). Applicable only for a Mesh-Client wireless network.
WBSn-2400 and WBSn-2450 System Manual
Table 3-1: Radio Operation Mode / Status
Icon
Description
Regular Access Point
Radio is disabled
Mesh Root Access Point
Mesh Access Point
"Wireless Network Page" on page
Status
77.
31