Alvarion WBSn-2400 System Manual page 80

Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management
The fallback IP parameters are the static IP parameters to be used when a DHCP server is not available.
The default values (Enable Fallback checked, IPv4 address 192.168.1.1, IPv4 netmask 255.255.255.0)
enable initial local management access for a new unit. Verify that these parameters are properly
configured and that configuration details are properly documented to ensure management access at all
times when for any reason DHCP server is not available.
3.5.1.2.5 DHCP Server
The DHCP Server option is available only in the LAN page when a static address is configured for the
interface (Protocol is set to Static address).
NOTE!
Do not enable the DHCP Server feature when the unit operates in Bridge mode.
In the default configuration only a single parameter is available in the DHCP Server section:
Ignore interface: Check (the default) to disable the DHCP server feature.
Uncheck the Ignore interface checkbox to enable the DHCP server and open the following tabs:
General Setup
Advanced Settings
3.5.1.2.5.1 General Setup
Figure 3-50: Network Per Interface Page, DHCP Server Section, Advanced Setup Tab
The General Setup tab includes the following parameters:
Start: The offset from the network IP address of the lowest address to be leased. The default is 100.
Limit: The maximum number of addresses to be leased. The default is 150.
WBSn-2400 and WBSn-2450 System Manual
Network
70