Table of Contents
Advertisement
Chapter 3 - Base Station ManagementSystem
Chapter 3 - Base Station Management
CAUTION
Check (the default) the Keep settings checkbox to save the previous configuration and continue using
it after switching to the new firmware version. If Keep settings is unchecked, the new firmware will
start running using the factory default configuration. In this case you may loose the ability to remotely
manage the device.
3.3.5.3
Firmware Banks
In the Firmware Banks section you can switch to the previous firmware version:
Each firmware has its own configuration file. After a firmware upgrade procedure is performed, a new
configuration file is included in the upgrade. This configuration file will adopt the current configuration
settings once the newly upgraded firmware is run. The new configuration file may contain new features
that could modify current configurations. Also, even if no new features are included in the upgrade, but
new configurations were specified by the user, a newer version of the configuration file is created.
If you wish to revert back to the previous firmware and keep using the new configuration file (excluding
parameters that are not supported by the previous firmware), click on the Switch Bank button. After
reboot the device will run using the previous firmware and the new configuration file.
If you wish to revert back to the previous firmware and the previous configuration file, you need to
perform a rollback procedure by clicking on the Rollback button. After reboot the device will run using
the previous firmware and the previous configuration file.
3.3.6
Reboot Page
To access the Reboot page click on the System>Reboot tab in the management function selection
panel.
WBSn-2400 and WBSn-2450 System Manual
Figure 3-33: System Backup / Flash Firmware Page, Firmware Banks Section
System
51
Advertisement
Table of Contents
