Table of Contents
Advertisement
Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management
NOTE!
If Hotspot service is enabled (see
before starting the process of switching from Router mode to Bridge mode.
1
In the LAN page:
a
In the Common Configuration select the General Setup tab. Change the Protocol to DHCP client
(you will be requested to confirm the action by clicking on the Switch protocol button that will
become available).
b
In the Management Interface parameter drop-down list select the Management option.
c
Make sure that the Fallback IP parameters (see
d
Click on the Save button.
2
In the Common Configuration section of the WAN page, select the Physical Settings tab. In the
Physical Settings tab select the No Interface option.
3
Click on Save & Apply to apply the changes.
3.5.1.2.3
Common Configuration
The Common Configuration section is available in all per interface pages.
The Common Configuration section includes the following tabs:
General Setup
Advanced Settings
Physical Settings
WBSn-2400 and WBSn-2450 System Manual
"Hotspot General Settings Page" on page
"Fallback IP" on page
Network
54, it must be disabled
69) are configured properly.
65
Advertisement
Table of Contents
