Alvarion WBSn-2400 System Manual page 91

Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management
3.5.2.2.2.1.2 Mesh Mode Parameters
Figure 3-59: Wireless Network Page, Interface Configuration Section, General Setup Tab
Mesh ID: The Mesh ID of the mesh network. Functionality is similar to that of SSID in regular Access
Point mode. All mesh network nodes must use the same Mesh ID.
Mesh Mode: The mesh node type. The available options are Root AP (RAP), Mesh AP (MAP) and
Root AP + Router Client.
The current (first wireless network in the radio) is always set to Mesh - Master (Access Point) mode.
The following wireless network(s), with the same Mesh ID, will be created automatically:
»
For Root AP mode: One additional wireless network (the second wireless network in the radio),
operating in Mesh - Monitoring mode (used for the batman-adv protocol).
»
For Root AP + Router Client: Two additional wireless networks will be created.
1
2
»
For Mesh AP: Two additional wireless networks will be created.
1
2
NOTE!
The configuration of the automatically created wireless network(s) cannot be modified.
WBSn-2400 and WBSn-2450 System Manual
The second wireless network in the radio, operating in Mesh - Monitoring mode.
The third wireless network in the radio, operating in Router - Client mode (used for
connectivity to the backbone).
The second wireless network in the radio, operating in Mesh - Monitoring mode.
The third wireless network in the radio, operating in Mesh - Client mode.
(Mesh Mode)
Network
81