Alvarion WBSn-2400 System Manual page 64

Chapter 3 - Base Station ManagementServices
Chapter 3 - Base Station Management
3.4.1.1.3 Test Internet Connection
At this point, before setting up the hotspot, it is recommended to test the Internet connection by
connecting a mobile phone or any other device to a wireless network in the LAN zone of the hotspot AP
and use a browser to perform an Internet search. If search results are returned, this means that the
Internet connection is working fine.
3.4.1.1.4 Setting up the Hotspot
The hotspot can now be set up and enabled. The following sections describe the Hotspot settings
available in the AP's web pages.
3.4.1.2 Hotspot General Settings Page
To access the Hotspot General Settings page click on the Services>Hotspot tab in the management
function selection panel.
The Hotspot General Settings page includes the following parameters:
Enable Hotspot: Select to activate the hotspot service. It is recommended to enable the hotspot
service after competing all necessary settings as described in
page 53.
WBSn-2400 and WBSn-2450 System Manual
Figure 3-36: Hotspot General Settings Page
"Introduction to Hotspot Services" on
Services
54