Table of Contents
Advertisement
Chapter 3 - Base Station ManagementServices
Chapter 3 - Base Station Management
3.4
Services
The Services tab provides access to the following:
Hotspot Service Pages
Discovery Page
3.4.1
Hotspot Service Pages
The Hotspot service allows you to control the access and usage of the Internet by connected devices.
This section includes:
Introduction to Hotspot Services
Hotspot General Settings Page
Hotspot Network Page
Hotspot RADIUS Page
Hotspot Authentication Page
User's Configuration Page
3.4.1.1
Introduction to Hotspot Services
The following subsections contain guidelines on how to configure the device to implement hotspot
services. It is recommended to configure the LAN, Wifi, and WAN, then test it before enabling the
hotspot setting:
WAN/LAN Interfaces
Wifi Settings
Test Internet Connection
Setting up the Hotspot
3.4.1.1.1
WAN/LAN Interfaces
To support Hotspot services configure the device to operate in Router mode. Refer to
Bridge Mode to Router Mode and Vice Versa" on page
3.4.1.1.2
Wifi Settings
The wireless networks that should be available for hotspot services should be set up to allow any user to
access the Internet, assuming that the hotspot is not yet enabled. This means:
ESSID should not be hidden (see Hide ESSID in
Wireless Security mode should be set to No Encryption (see
WBSn-2400 and WBSn-2450 System Manual
64.
"General Setup" on page
80).
"Wireless Security" on page
Services
"Switching from
82).
53
Advertisement
Table of Contents
