Alvarion WBSn-2400 System Manual page 42

Chapter 3 - Base Station ManagementStatus
Chapter 3 - Base Station Management
RX Rate: The current receive bit rate in the uplink. Applicable only for a Mesh-Client wireless
network.
TX Rate: The current transmit bit rate in the uplink. Applicable only for a Mesh-Client wireless
network.
3.2.1.7 Associated Stations
This section shows the following details for each of the end-user devices connected to the AP.
MAC-Address: Displays the MAC address of the station's radio.
Network: States the name of the wireless network (SSID) to which the device is connected. You can
click on the link to open the applicable page.
Device Name: Shows the name of the station.
Last IP: States the most recent IP address of the station as seen by the AP.
Signal: The current total strength (in dBm) of the signal received from the station.
Signal/Chains: The current strength of the signal received from the station per chain (the value of
-95 dBm is taken to mean "no antenna").
Noise: The current received noise level at the AP.
TX Rate: The current transmit bit rate from the AP towards this station.
RX Rate: The current receive bit rate at the AP from this station.
TX-CCQ: The current transmission quality in % (a higher percentage means a better wireless
connection quality).
The signal quality icon is displayed on the left side of each entry. Hover with the mouse over the icon to
see the signal and noise levels.
If there are no associated stations, the text "No information available" is displayed.
WBSn-2400 and WBSn-2450 System Manual
Figure 3-11: Status Overview Page, Associated Stations Section
Status
32