Alvarion WBSn-2400 System Manual page 87

Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management
MAC-Address: Displays the MAC address of the station's radio.
Network: States the name of the wireless network (SSID / Mesh ID) to which the device is connected.
Signal: The total strength (in dBm) of the signal received from the station.
Signal/Chains: The strength of the signal received from the station per chain (the value of -95 dBm is
taken to mean "no antenna").
Noise: The received noise level at the AP.
TX Rate: The transmit bit rate from the AP towards this station.
RX Rate: Shows the receive bit rate at the AP from this station.
TX-CCQ: The transmission quality in % (a higher percentage means a better wireless connection
quality).
3.5.2.2 Wireless Network Page
A Wireless Network page is available for each configured wireless network.
The page title is "Wireless Network <Mode> <Network Name (SSID)> (<ath#>)". In current release
Mode is always Master and ath# indicates the number of the wireless network interface, where # can be
from 0 to 5 for the 2.4 GHz radio (wifi0) and from 6 to 11 for the 5 GHz radio (wifi1).
To open the Wireless Network page for a specific wireless network:
From the management function selection panel, click on the relevant tab.
From the Wifi Wireless Overview page, click on the relevant Edit button.
From the Status Overview page, click on the SSID's name in the Wireless section.
The Wireless Network page includes the following sections:
WBSn-2400 and WBSn-2450 System Manual
Figure 3-55: Wifi Wireless Overview Page, Associated Stations Section
Network
77