Table of Contents
Advertisement
Chapter 2 - Base Station InstallationAttaching an Extender to the Post Clamp (optional)
Chapter 2 - Base Station Installation
The extender kit includes also 4 screws with attached spring and flat washers.
To attach the extender to the post-clamp:
1
Attach the horizontal adjustment part of the extender to the post clamp with 2 screws and washers
using a 13 mm ratchet key with a torque of 18.4 lb-ft (25 Nm).
2
Attach the vertical adjustment part to the horizontal adjustment part with 2 screws and washers
using a 13 mm ratchet key with a torque of 18.4 lb-ft (25 Nm).
WBSn-2400 and WBSn-2450 System Manual
Horizontal Plane Adjustment
Figure 2-3: Extender and Post-Clamp Attached
Attaching an Extender to the Post Clamp (optional)
Vertical Plane Adjustment
Figure 2-2: Extender Parts
14
Advertisement
Table of Contents
