Transferring Full Disclosure Recording Using Wifi - ZOLL M2 Operator's Manual

Transferring Full Disclosure Recording Using WiFi

For units with an SFTP server configured, the ZOLL M2 unit allows you to send patient
disclosure logs to a remote server through a wireless connection. WiFi and SFTP settings can
be configured in the Supervisor System Main menu. If the WiFi and SFTP server settings have
not been configured, see "Setting Up a Wireless Configuration/SFTP Server" on page 12-17
before completing the following procedure.
Note:
To transfer a full disclosure recording through WiFi:
1. Press the More quick access key (
Press the Data quick access key (
2.
3. Press Transfer quick access key (
displays.
Last
recorded
incident
Rotate the Trim Knob to select WiFi as the Transfer Type then press the knob to select it.
4.
Rotate the Trim Knob to highlight a rescue incident, then press the knob to select it (a green
5.
check marker displays next to the incident). Rotate the Trim Knob to highlight Transfer
Selection and then press the knob to select it.
6. When the transfer is finished, the message RESCUE DATA TRANSFER - SUCCESSFUL
displays.
Do one of the following:
7.
Rotate the Trim Knob to the X in the top right corner of the window and press the knob
•
to leave the window.
Press the Menu button
•
9650-000860-01 Rev. C
The ZOLL M2 unit automatically cancels any full disclosure log transmissions when
defibrillation is activated.
(
ZOLL M2 Operator's Guide
) until the Data quick access key displays.
).
). The Select Rescue Incident to Transfer window
to leave the window.
)
Full Disclosure Recording
12-15