ZOLL M2 Operator's Manual page 79

This chapter describes how to use the ZOLL M2 unit to monitor SpO
The ZOLL M2 SpO
peripheral site, such as finger:
Oxygen saturation of arterial hemoglobin (SpO
•
Pulse rate (PR)
•
SpO monitoring and related accessories are to be used only on adult and pediatric patients.
2
This monitoring gives information about the cardiac and respiratory systems, and provides
details of oxygen transportation in the body. It is widely used because it is noninvasive,
continuous, easily applied, and painless.
Warning! Do not reuse any components that are labeled for single use only.
The ZOLL M2 SpO
sensors. The SpO
light through the body's extremities. The transmitted light is then received by a photodetector
within the sensor, which converts it to an electronic signal. The signal is then sent to the ZOLL
M2 unit for processing.
9650-000860-01 Rev. C
Monitoring SpO
ZOLL M2 SpO2 sensors are a defibrillation-protected Type BF patient connection
(applied part).
module continuously and noninvasively measures the following at a
2
module (optional) is intended for use only with ZOLL M2 pulse oximetry
2
sensor contains light-emitting diodes (LEDs) that transmit red and infrared
2
ZOLL M2 Operator's Guide
Chapter 7
and pulse rate.
2
)
2
2
7-1