ZOLL M2 Operator's Manual page 148

Chapter 12 Incident Data and Reports
Note:
To transfer data do the following:
1. Press the More quick access key (
Press the Data quick access key (
2.
3. Press Transfer quick access key (
displays.
Last
recorded
incident
Rotate the Trim Knob to select USB as the transfer type, then press the knob to select USB.
4.
To transfer:
5.
Specific incident(s) - rotate the Trim Knob to highlight a rescue incident, and press the knob
to select it (a green check marker displays next to the incident). Rotate the Trim Knob to
highlight Transfer Selection and then press the knob to select it.
All incidents - rotate the Trim Knob to highlight Transfer All and then press the knob to
select it.
When the transfer is finished, the message RESCUE DATA TRANSFER - SUCCESSFUL
6.
displays.
Do one of the following
7.
Rotate the Trim Knob to the X in the top right corner of the window and press the knob
•
to leave the window.
Press the Menu button
•
Note:
Warning! To avoid a possible shock hazard, do not make any electrical connections to the USB
port except to connect a USB flash drive while the ZOLL M2 unit is connected to or
within touching distance of the patient.
12-14
If the USB device does not establish communication with the ZOLL M2 unit, turn off
the unit and then turn it back on again to establish communication.
(
Do not remove the USB device from the ZOLL M2 unit during transfer.
www.zoll.com
) until the Data quick access key displays.
).
). The Select Rescue Incident to Transfer menu
to leave the window.
)
9650-000860-01 Rev. C