Table of Contents
Advertisement
a. From the boot screen, press F9 to run UEFI System Utilities.
b. Select System Configurations > BIOS/Platform Configuration (RBSU) > Storage Options > SATA
Controller Options > Embedded SATA configuration > Smart Array SW RAID Support.
c. Enable SW RAID.
d. Save the configuration and reboot the server.
e. Create an array using either the UEFI System Utilities or HPE Smart Storage Administrator. To use the
UEFI System Utilities:
I.
II.
For more information on creating arrays using the HPE Smart Storage Administrator, see the HPE Smart
Array SR Gen10 Configuration Guide at https://www.hpe.com/support/SSC-config.
9.
Set the server power supply requirements.
10. To deploy an OS or virtualization software, do one of the following:
•
To deploy an OS, run Intelligent Provisioning.
Press F10 at the boot screen.
IMPORTANT: Smart array MR controllers are not supported by Intelligent Provisioning or Smart Storage
Administrator.
•
Manually deploy an OS.
a. Insert the installation media.
For remote management, click Virtual Drives in the iLO remote console to mount images, drivers, or files to a
virtual folder. If a storage driver is required to install the OS, use the virtual folder to store the driver.
b. To select the boot device, press F11 at the boot screen.
c. After the OS is installed, update the drivers.
11. Register the server (http://www.hpe.com/info/register).
General site planning
Before you begin installing the HPE Apollo 6500 Gen10 Plus System, Hewlett Packard Enterprise recommends that you
plan and coordinate the installation process with an authorized HPE representative or partner. Proper planning provides a
more efficient installation process and leads to greater availability, reliability, and serviceability of the system.
Operational requirements
Site requirements
The server must be located in a computer room or server room. The room must:
IMPORTANT: HPE Smart Array S100i SR Gen10 SW RAID is only supported on Windows. For more
information on Linux and VMware support, see the product QuickSpecs on the Hewlett Packard
Enterprise website (https://www.hpe.com/info/qs).
From the boot screen, press F9 to run UEFI System Utilities.
Select System Configuration > Embedded Storage: HPE Smart Storage S100i SR Gen10 > Array
Configuration > Create Array.
42
Setup
Advertisement
Table of Contents
