Table of Contents
Advertisement
5. Connect the power cords to the rear of the chassis.
6. Connect the system to the power source.
WARNING: To reduce the risk of electric shock or damage to the equipment:
•
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
•
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
•
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed against it. Pay particular
attention to the plug, electrical outlet, and the point where the cord extends from the server.
Installing the product in the rack
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately
stabilized before installing the chassis.
WARNING: To reduce the risk of personal injury or equipment damage, do one the following:
•
If the chassis is empty, use at least 2 people to lift and stabilize the product pieces during assembly.
•
If the chassis is fully loaded, use at least 4 people to lift and stabilize the product pieces during assembly.
•
Use a lift that can handle the load of the product.
CAUTION: Be sure to keep the product parallel to the floor when installing the chassis. Tilting the product up or
down could result in damage to the slides.
Procedure
WARNING: On both sides, align the three alignment pins on the chassis with the channel in the rails. Otherwise, the
chassis can fall if the rack is moved or shipped.
48
Setup
Advertisement
Table of Contents
