Table of Contents
Advertisement
•
SAS Secondary Riser to Half Width System Board M.2 cable
•
At least one M.2 SSD module
Procedure
1.
Power down the server.
2.
Disconnect all peripheral cables from the server.
3.
Remove the system board module from the chassis.
4.
Place the system board module on a flat, level work surface.
5.
Remove the system board module access panel.
6.
Remove the midplane interposer.
7.
Install the M.2 SSD drives on the boot controller:
a. Install an M.2 SSD on drive bay 2.
b. Turn over the boot controller.
c. Install an M.2 SSD on drive bay 1.
8.
Install the boot controller on the system board.
Hardware options installation
78
Advertisement
Table of Contents
