Table of Contents
Advertisement
•
Locally: Use a KVM switch or a connect a keyboard, monitor, and mouse.
•
Remotely: Connect to the iLO web interface and run a remote console:
a. Verify the following:
◦
iLO is licensed to use the remote console feature.
If iLO is not licensed, visit http://www.hpe.com/info/ilo.
◦
The iLO management port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
https://<iLO hostname or IP address>
Note the following:
◦
The hostname is on the serial pull tab.
◦
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
◦
If a static IP address is assigned, use that IP address.
◦
The default login credentials are on the serial label pull tab.
c. In the side navigation, click the Remote Console & Media link, and then launch a remote console.
6.
Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
7.
Using the SPP, update the following:
•
System ROM
•
Storage controller
•
Network adapters
•
Intelligent Provisioning
8.
To set up storage, do one of the following:
To configure the server to boot from a SAN, see the HPE Boot from SAN Configuration Guide guide at https://
•
www.hpe.com/info/boot-from-san-config-guide.
•
If an SR controller is installed, use HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run HPE Smart Storage Administrator.
For more information, see the HPE Smart Array SR Gen10 Configuration Guide at https://www.hpe.com/
support/SSC-config.
•
If no controller is installed, do one of the following:
◦
AHCI is enabled by default. Proceed with deploying an OS or virtualization software.
◦
Disable AHCI, enable software RAID, and then create an array:
41
Setup
Advertisement
Table of Contents
