Table of Contents
Advertisement
7.
Remove the system board module access panel.
8.
Remove any components or cables that may prevent access to the processor socket.
9.
Remove the dust cover from the processor socket you intend to upgrade.
10. Use a T-20 Torx screwdriver to loosen the three captive screws in the sequence shown in the following image, and
then pivot the force frame upward.
11. Remove the external cap:
a. Hold the lift tabs near the front end of the rail frame, and then pivot the rail frame to the vertical position.
b. Slide the external cap out of the rail frame.
Retain the external cap for future use.
12. Install the processor:
a. Hold the processor by its carrier handle and slide the processor into the rail frame until it engages with a click
sound.
b. Remove the pin field cover cap.
CAUTION: To prevent the risk of damaging the pins in the processor socket, do not reinstall the pin field
cover cap after removing it.
c. Hold the lift tabs near the front end of the rail frame, and then pivot the rail frame to the closed position.
Hardware options installation
73
Advertisement
Table of Contents
