Insertion/Extraction Of The Electronic Module; Marking Label - WAGO CANopen 752 Manual

4.1.2 Insertion/Extraction of the Electronic Module

The electronic module is plugged onto the base module.
Attention
Remove power from the base module before installing the electronic module.
Apply force at the positions marked "PUSH" when plugging in the electronic
module.
CANopen
Fig. 4-3: Plugging in the Electronic Module
The electronic module is correctly inserted when all four latches have en-
gaged.
CANopen
Fig. 4-4: Extracting the Electronic Module
The electronic module can be extracted by pressing the 4 latches and simulta-
neously pulling it from the base module.

4.1.3 Marking Label

The plastic marking label can be removed from the mounting points by ap-
plying slight finger force. To accomplish this, slide the label from one side
such that the label bends.
Insert the label by proceeding in the reverse order.
Fieldbus Dependent I/O Module
CANopen
PUSH
PREPARED
RUN
TXOVERF
RXOVERF
OVERLOAD
WAGO-I/O-SYSTEM 752 16DI/16DO
Latch
PUSH
PREPARED
RUN
TXOVERF
RXOVERF
OVERLOAD
WAGO-I/O-SYSTEM 752 16DI/16DO
Latch
PUSH
752-327
PUSH
752-327
Installation • 13
g1x2802x
g1x2803e