Installing The Conductivity Sensor (Optional) - horiba TW-150 Instruction Manual

2.3

Installing the Conductivity Sensor (optional)

1. Make sure that the stop valve is closed and the power is OFF.
2. Loosen the screws and remove the cover.
3. Remove the cap from the conductivity sensor.
Note
Be careful not to lose the protective cap, as it will be used to store the sensor.
4. Install the conductivity sensor to the electric conductivity sensor's installation
position in the residual-chlorine/conductivity cell.
Stop valve must be closed.
5. Connect the sensor connector.
6. Attach the cover and tighten the screws.
Screw
Cover
Enlarged
view
Conductivity sensor connector
2 PREPARATION
Conductivity sensor
Installation position
9