Table of Contents
Advertisement
1 OVERVIEW
1.2.2
Display
This section explains the contents of the display, using a typical screen as an example.
The screen is equipped with a touch panel. Do not operate touch panel with wet finger or
solid tools, such as pen or driver.
The measurement items pH, conductivity and water temperature are optional and not
included in the standard configuration.
If the touch panel is not operated for a certain amount of time, the backlight is turned to
OFF.
If not in the MEASUREMENT, DATA or ALARM screens, the display returns to the
measurement screen after about two hours of inactivity.
Screen example - Displaying the values of measured items
This screen displays the values for each measured item.
No.
Contents
Screen title
①
Clock display
②
Measurement
③
item
Measurement
④
value
Unit
⑤
Operation
⑥
buttons
System status
⑦
4
①
③
④
⑤
⑥
MEASUREMENT, SPAN CAL..., DATA HISTORY
2004/01/30 09:57
TURB., COL., FRC.
-
NTU, TCU, mg/L, etc.
MAINTE., CAL., etc.
WARM UP!
Seq.
MAINTENANCE
⑦
Examples
The device is warming up
The device is always warmed up when the power is turned
on. The alarm display is cleared when the temperature of
the turbidity/color cell becomes stable.
Action operation
The device is performing automatic calibration, automatic
cleaning and alarm check setting, or the operations are
finished and output is on hold .
Maintenance mode
The device is in maintenance mode.
See"3.4 Maintenance Mode" (page 15).
②
Advertisement
Table of Contents
