Measurement Settings - horiba TW-150 Instruction Manual

5 FUNCTION
5.10

Measurement Settings

The following are available for configuring measurement settings.
Measurement
Setting
item
HIGH ALARM
（5.14.6, page 123）
LOW ALARM
（5.14.7, page 124）
All UNIT HIGH ALARM
Measurement
（5.14.8, page 125）
Items
UNIT LOW ALARM
（5.14.9, page 126）
COEFFICIENTS
（5.10.1, page 100）
RANGE
Turbidity
（5.10.2, page 101）
RANGE
（5.10.2, page 101）
Color
TURB.
COEFFICIENTS
（5.10.3, page 102）
APPLIED VOLTAGE
（5.10.4, page 103）
Residual
chlorine
RANGE
(5.10.5,page 103)
Water UNIT
pressure (5.10.6,page 104)
Conductivity RANGE
(optional) (5.10.7,page 104)
98
See "5.14 Alarm" (page 119).
Even after calibration, measured values can deviate from their
actual values for a variety of reasons, so the coefficients can
help correct these values.
Sets the measurement range.
Sets the measurement range.
You can correct color when a measurement value deviates from
the actual value by using the turbidity.
Specifies the applied voltage.
Sets the measurement range.
Sets the measurement unit.
Sets the measurement range.
Description Initial Setting
a=0
b=1.000
0-10
0-20
0.000
50 mV
0-5
MPa
0-1000