Las-Light & Output Settings - Christie 4K35-RGB Technical Reference

Command Description
KEN+WIRE? Returns the current wired jack enabled
state. (Read-only)
KEN+WIRE <0 | 1> Enables or disables the wired keypad sensor.
(Saved value)
Examples
Get the current wired jack enabled state:
(KEN+WIRE?)
Disable the front IR sensor:
(KEN+FRNT 0)
Disable the rear IR sensor:
(KEN+REAR 1)
LAS–Light & Output Settings
Configures the laser drive levels and uses the projector's LiteLOC
Commands
Command Description
LAS+BLUP <value> Sets the drive level of the blue lasers. The
actual value sent to the laser rack is
reduced based on the Master Laser Power.
Expressed as percentage with one decimal
point.
LAS+CSRX? Returns the color sensor X reading. (Read-
only)
Only applies to: Christie M RGB Series and
Griffyn Series
LAS+CSRY? Returns the color sensor Y reading. (Read-
only)
Only applies to: Christie M RGB Series and
Griffyn Series
LAS+CSRZ? Returns the color sensor Z reading. (Read-
only)
Only applies to: Christie M RGB Series and
Griffyn Series
LAS+EBLU <0 | 1> Enables or disables the blue lasers.
LAS+EGRN <0 | 1> Enables or disables the green lasers.
Christie TruLife+ Technical Reference–Serial Commands
020-103316-07 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Serial API commands
Values
—
0 = Disables the wired keypad jack
1 = Enables the wired keypad jack (Default)
feature.
™
Values
0 to 1000, where 1000 = 100%
635 (Default)
—
—
—
0 = Disables the blue lasers
1 = Enables the blue lasers (Default)
0 = Disables the green lasers
39