Christie 4K35-RGB Technical Reference page 40

Command Description
LAS+ERED <0 | 1> Enables or disables the red lasers.
LAS+GRNP <value> Sets the drive level of the green lasers. The
actual value sent to the laser rack is
reduced based on the Master Laser Power.
(Saved value)
Expressed as percentage with 1 decimal
point.
LAS+MAXA <value> Configures the projector to operate correctly
up to the specified maximum ambient
temperature in Celsius. (Saved value)
Only applies to: Christie M RGB Series and
Griffyn Series
LAS+MAXH <value> Sets the expected relative humidity in
percent of the environment where the
projector is operating. (Saved value)
This is only applicable if the projector is
running LiteLOC
Only applies to: Christie M RGB Series and
Griffyn Series
LAS+MODE <value> Enables or disables LiteLOC.
Only applies to: Christie M RGB Series and
Griffyn Series
LAS+POWR <value> Adjusts the overall output of the lasers while
maintaining the overall ratio of power
between each color. (Saved value)
Expressed as percentage with one decimal
point.
LAS+REDP <value> Sets the drive level of the red lasers. The
actual value sent to the laser rack is
reduced based on the Master Laser Power.
(Saved value)
Expressed as percentage with one decimal
point.
LAS+UDEC <value> Enables either automatic or manual setting
of LiteLOC user defined environmental
controls. (Saved value)
The manual selection allows user selection
of LAS+MAXA and LAS+MAXH values.
Only applies to: Christie M RGB Series and
Griffyn Series
Christie TruLife+ Technical Reference–Serial Commands
020-103316-07 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™
with User mode active.
Serial API commands
Values
1 = Enables the green lasers (Default)
0 = Disables the red lasers
1 = Enables the red lasers (Default)
0 to 1000, where 1000 = 100%
615 (Default)
0 to 50
35 (Default)
0 to 100
80 (Default)
0 = LiteLOC 1 (deprecated)
1 = Disables LiteLOC
2 = LiteLOC 2 (deprecated)
3 = Enables LiteLOC (Default)
0 to 1000, where 1000 = 100%
750 (Default)
0 to 1000, where 1000 = 100%
820 (Default)
0 = Automatic—the software calculates the
maximum ambient and humidity conditions
(Default)
1 = Manual selection—allows for more user
tuning in LiteLOC
40