Enabling The 12V Trigger; Enabling High Altitude Setting; Adjusting The Back Light Settings; Setting The Hot Key - Christie D13WU2-HS User Manual

Enabling the 12V Trigger

The 12V trigger is used for electrical projector screens. The projector screen is automatically
lowered or raised when the projector is switched on or off.
1. Select Menu > Configuration > 12V Trigger.
2. To swap, press ENTER.

Enabling high altitude setting

Enable high altitude mode when altitudes >/= 2000 m. The fan operates at high speed to ensure
sufficient air flow for high altitudes; however, the noise level of the projector is increased.
1. Select Menu > Configuration > High Altitude.
2. To swap, press ENTER.

Adjusting the back light settings

Control the back light behavior and timeout setting for the keypad and status LED.
1. Select Menu > Configuration > Backlight Preferences > Keypad Backlight.
2. Select the appropriate setting for keypad backlight.
3. To confirm the selection, press ENTER.
4. Select Menu > Configuration > Backlight Preferences > Status LED.
5. Select the appropriate setting for status LED.
6. To confirm the selection, press ENTER.

Setting the hot key

To directly call out a function without going through the layers of the on-screen display (OSD)
menus, select a specific function for a hot key. To access this function, press HOT KEY on the
remote control.
1. Select Menu > Configuration > Hot-Key Settings.
2. Select the one function for the hot key:
• Size Presets
• Picture Settings
• Default Value
• Detail
• Contrast Enhancement
• Light Source Mode
HS Series 2K User Manual — D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001466-06 Rev. 1 (12-2022)
Copyright ©2022 Christie Digital Systems USA Inc. All rights reserved.
Configuring system settings
51