Table of Contents
Advertisement
Examples
Set the splash screen to blue:
(SPS+COLR 3)
SSP–Shifted Superposition
Enables or disables the shifted superposition mode for projectors using actuator based resolution
enhancement.
Only applies to: Christie M RGB Series
When actuation is enabled, the projector resolution is two times in each direction. When disabled, the
projector runs at the native resolution of the DMD device.
This command may cause video artifacts when enabled or disabled and it impacts many aspects of the
video pipe. Service menu access is required to change this command.
Commands
Command
Description
SSP+SLCT?
Returns the state of the actuator. (Read-
only)
SSP+SLCT <0 | 1>
Enables or disables the shifted superposition
mode for projectors. This change can be
made when the video pipe is on or off.
SSP+TMUL <val>
Turns on or off the actuator multiplication
mode. When enabled, the actuator is run
two or four times the input frame rate and is
used to improve display artifacts occurring
on fine detail content.
Examples
Turn off the actuator:
(SSP+SLCT 0)
Turn on the actuator:
(SSP+SLCT 1)
Get the enable state of the actuator:
(SSP+SLCT?)
Christie TruLife+ Technical Reference–Serial Commands
020-103316-07 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Serial API commands
Values
—
0 = Disables the actuator
1 = Enables the actuator (Default)
0 = Disables the actuator multiplication
mode
1 = Enables the actuator multiplication
mode (Default)
55
Advertisement
Table of Contents
