Table of Contents
Advertisement
Meanings of Each Item in Function Code Parameter Table
Item
Function code number
Function code name
Factory setting
Setting range
Unit
Property
Function code
selection
User setting
Note: ◆ E5 series inverter built−in multi fan and pump control mode to realize customsized energy saving
requirement. For details, refer to the descriptions of function code of Pb.21 and Pb.22.
◆ E5 series inverter built−in constant pressure close loop control and sleeping function. For details,
refer to the descriptions of function code of group H0.
5.1 List of Basic Menu Function Codes
Function
code
Function code name
number
P0.00
User password
Function code
P0.01
protection
P0.02
Function code display
P0.03
Control operation mode
Open loop main
P0.04
reference mode
38
E5−H High Performance Universal Inverter
Chapter 5 List of Parameters
The number of function code, such as P0.00
The name of function code, which explains the function code's meanings.
Restore the settings of the function code after the inverter is delivered (see P0.01).
The value from minimum value to maximum value that can be set to this function code.
V: Voltage; A: Current; ºC: Celsius degree; Ω: Ohm; mH: Milli−henry; rpm: Rotating speed; %:
Percentage; bps: baud rate; Hz, kHz: Frequency; ms, s, min, h, kh: Time; kW: Power; Mpa:
Pressure; /: No unit
○: This function code can be changed during operation; ×: This function code can only be
changed during stopping process; *: The setting of this function code is read−only and cannot
be changed.
Function code parameter setting list
Used for recording parameters by user
Factory
Setting range
setting
Group P0
0000
0 ~FFFF
0
0 ~ 5
0
0 ~ 3
0
0 ~ 1
0
0 ~ 4
Chapter 5 List of Parameters
M e a n i n g s
Unit
Property
Basic Function Parameter
/
○
/
×
/
○
/
×
/
×
User Manual
Function code selection
0000: No password;
Other: Password protection
0: All the parameters can be modified;
1: All the parameters cannot be
modified;
2: Restore parameters in zone P to
factory settings;
3: Restore parameters in zone P to
factory settings; (except for P9 group)
4: Recover the parameters in zone P
and zone A to factory settings;
5: Recover all the parameters to
factory settings. (except for d group)
0: Basic menu mode
1: Fast menu mode
2: Menu mode of non−factory setting
value function codes;
3: Menu mode of last changed 10
function codes;
0: Process open loop control;
1: Analog value feedback process
close loop control
0: Open loop digital frequency
reference (P0.05);
1: AI1 analog value reference;
2: AI2 analog value reference
User
setting
Advertisement
Table of Contents
