Table of Contents
Advertisement
Unit place: Action upon mains loss
0: After setting frequency by operational panel ∧/∨ adjustment, operational panel ∧/∨ adjustment
volume will be recorded automatically after power to the inverter is cut off.
1: After setting frequency by operational panel ∧/∨ adjustment, operational panel ∧/∨ adjustment
volume will be cleared automatically after power to the inverter is cut off.
Tens place: Action during stopping process
0: After the inverter stops, adjustment volume of ∧/∨ on operational panel keeps unchanged.
1: After the inverter stops, adjustment volume of ∧/∨ on operational panel will be cleared after carrying
out stop command.
2: After the inverter stops, adjustment volume of ∧/∨ on operational panel is cleared under the stop
status. Frequency cannot set by ∧/
Hundreds place: Setting of
0: Only enabled when the main reference is P0.05 open loop digital frequency setting (P0.04=0).
1: Enabled under all frequency reference modes (P0.04 not specified).
2: Operational panel adjustment
Thousands place: Setting of
0: With integral function. When the operation panel
consistent adjustment in one direction has integral effect. The step length of adjustment starts from
0.01Hz, after every 10 times of adjustment, the step length will be increased by 10 times, and the
maximum step length of adjustment is 1.00Hz.
1: Without integral function. When the operation panel
step length of the adjustment is fixed to 0.1Hz.
Note: When operating under process closed loop PID, the closed loop reference also can be adjusted
with operational panel
closed loop reference. The minimum step size is 1mV.
Pb.10
Terminal UP/DN digital regulating frequency control
Pb.11
E5−H High Performance Universal Inverter
Display of operational panel
Action when power failure
Unit place
0: mains loss save;
1: reset upon mains loss
Action when stop
0: Maintain when stop;
Tens place
1: Reset clear when deceleration or stop;
2: Reset during standby
Operational panel ∧ / ∨ regulation setting
0: Only enabled when main reference is
Hundreds
P0.05 open loop digital frequency setting
place
1: Enabled during adjustment;
2: Disabled during adjustment
Thousands
0: With integral function;
place
1: Without integral function
under the stop status.
∨
/
on operational panel
∧ ∨
/
disabled.
∧ ∨
/
on operational panel
∧ ∨
/ . Then adjustment volume of
∧ ∨
Terminal UP/DN integral rate
Chapter 6 Parameter Description
User Manual
/
adjustment is used to set the frequency, the
∧ ∨
∧ ∨
/
adjustment is used to set the frequency, the
/
is regarded as analog superimposed upon
∧ ∨
0000~1221(0001)
0.1~50.0 s(2.0s)
97
Advertisement
Table of Contents
