V&T E5-H Series User Manual page 38

4.4.4 Common Characters Displayed by LED
Except the function codes in first and second level menus, the operation panel will also display the
following characters as shown in the following table:
Prompt
symbol
Instantaneous display of inverter when inverter
8.8.8.8.
is powered on
−LU− Inverter shutdown due to under voltage
−dc− Inverter is in DC braking status
−At− Inverter is in auto tuning
bASE Basic menu (P0.02=0)
Inverter parameters are being downloaded and
this symbol will be displayed when parameters
CoPy
are downloaded to inverter. For example, set
Pb.23=2 or 3
dEFt Restore to factory settings (P0.01=2 to 5)
E. means fault or alarm happens. Analyze the
fault or alarm according to the fault or alarm
E.XXX
list
in 7.1
FASt Fast menu (P0.02=1)
The parameter copy or upload function of
HoLd
operation panel is disabled
LASt 10 function codes modified recently (P0.02=3)
LInE Communication of operation panel fails
If the symbol is not listed in the table, please contact the local distributor or our company directly.
E5−H High Performance Universal Inverter
Meaning
Chapter 4 Using Instructions of Operation Panel
User Manual
Prompt
symbol
Inverter parameters are being copied and
this symbol
LoAd
parameters are uploaded to operation panel.
For example, set Pb.23=1
Operation panel is locked and the keys are
Loc1
disabled
Loc2 Except M key, other keys are locked
Except RUN and STOP/RST keys, other
Loc3
keys are locked
Non factory
ndFt
(P0.02=2)
Password is cleared, see 4.5 for password
P.CLr
operation
Password is set successfully, see 4.5 for
P.SEt
password operation
Password protection is enabled, see 4.6 for
Prot
key locking and unlocking
SLId Operation panel is identified as shuttle type
Press ESC+>>+ ∨ together to unlock the
ULoc
panel
UpDn Operation panel is identified as key type.
− SL − The inverter in sleeping status
Meaning
will be displayed when
setting of function code
31