V&T E5-H Series User Manual page 101

PA.16
PA.17
PA.18
The function can be used to manage various actions when some failures occur. When these failures
occur under some special circumstances, inverter shall alarm immediately but not stop. Alarm
information is displayed on the operational panel and even the failure is to be shielded.
Unit place, tens place, hundreds place and thousands place displayed on operational panels from PA.16
to PA.18 can be set:
0: Failure not shielded and alarm and stop during failure.
1: Failure not shielded and alarm but not stop during failure.
2: Failure shielded, neither alarm nor stop.
Note: To change factory−setting, please contact with distributor or manufacturer.
PA.16 failure shield and alarm attribute setting 1
Unit place
Tens place
Hundreds place
Thousands place
PA.17 failure shield and alarm attribute setting 2
Unit place
Tens place
Hundreds place
Thousands place
94
E5−H High Performance Universal Inverter
Figure 6−34 Overload prealarm detection signal
Fault shielded and alarm attribute setup 1
Fault shielded and alarm attribute setup 2
Fault shielded and alarm attribute setup 3
Display of operation panel
Output short circuit to ground abnormality
Power failure abnormality during running
Input power abnormality
Output phase loss
Display of operational panel
EEPROM abnormality
Relay contact abnormality
Temperature sensor taking sample anomaly
Reserved
Chapter 6 Parameter Description
User Manual
0000 ~ 2222(0020)
0000 ~ 2222(0000)
0000 ~ 2222(2000)