V&T E5-H Series User Manual page 69

all the function codes.
7: Realize the circular switching of the display modes of last changed 10 function codes and all the
function codes.
8: Realize the circular switching of different function code display modes (basic menu mode → fast menu
mode → menu mode of non−factory setting function code→Menu mode of last changed 0 function codes,
refer to description of P0.02 for the menu modes.
P2.02
Up to 4 parameters can be set and display at running status, and viewed circularly by pressing >>key.
Unit place:
Tens place
Hundreds place
Thousands place
P2.04
P2.05
If the parameter to be displayed has proportion relation with a physical value in the operation display
parameter defined by P2.02, P2.04 can be used to designate the physical value as the display
benchmark, and P2.05 can be used to set the coefficient of the display benchmark.
When the proportion display parameter is set (i.e. P2.05≠0), the physical value will be automatically
added into the operation display parameter group and can be viewed by pressing >>key. At this time,
there are 5 display parameters. The LEDs for the newly added parameter are LED A and LED V, both of
which shall be on.
P2.03
Up to 4 parameters can be set and display in stopping status, and viewed circularly by pressing >>key.
62
E5−H High Performance Universal Inverter
Display parameter selection at running status
Display of operation panel
0: Reference frequency (Hz) ;
2: AI1 (V) ;
4: Reserved;
6: External counts
8: Close loop reference (%);
A: Reserved;
C: Output current (A);
E: Output power (kW);
Same as above
Same as above
Same as above
Running proportion display benchmark
Running proportion display coefficient
Displayed parameter selection in stopping status
Chapter 6 Parameter Description
User Manual
0~FFFF(1CB0)
1: Bus voltage (V) ;
3: AI2 (V) ;
5: Reserved;
7: Motor rotation speed (rpm);
9: Close loop feedback (%);
B: Operating frequency (Hz);
D: Output torque (%);
F: Output voltage (V)
0~F(0)
0.0~655.35% (0.00%)
0~FFFF(3210)