Chapter 4 Crane Special Inverter Parameters Lists - V&T V5 Series User Manual

Chapter 4 Crane special inverter parameters lists

Meaning of each item in function code parameter table:
Item
Function code
Function code name
Factory setting
Setting range
Unit
Property
Function code
selection
Function
code Function code name
number
P0.00 User password
Function code
P0.01
protection
Function code
P0.02
display
Control operation
P0.03
mode
Open loop main
P0.04
reference mode
Open loop digital frequency
P0.05
reference
Running command
P0.06
reference mode
high performance crane special inverter User Manual
The number of function code, such as P0.00
The name of function code, which explains the function code's meanings.
Restore the settings of the function code after the inverter is delivered (see P0.01).
The value from minimum value to maximum value that can be set to this function code.
V: Voltage; A: Current; ºC: Celsius degree; Ω: Ohm; mH: Milli−henry; rpm: Rotating speed; %:
Percentage; bps: baud rate; Hz, kHz: Frequency; ms, s, min, h, kh: Time; kW: Power; /: No unit
○: This function code can be changed during operation; ×: This function code can only be
changed during stopping process; *: The setting of this function code is read−only and cannot be
changed.
Function code parameter setting list
Factory
Setting range
setting
Group P0 Basic Function Parameter
0000 0～FFFF
0 0～5
0 0～3
0 0～11
00 00～FF
10.00 0.00～300.00
0 0～2
Chapter 4 Crane special inverter parameters lists
meaning
Unit Property
0：No password;
/ ○
Other: Password protection
0: All the parameters can be modified;
1: All the parameters cannot be modified;
2: Restore parameters in zone P to factory settings;
3: Restore parameters in zone P to factory settings;
/ ×
(except for P9 group)
4: Recover the parameters in zone P and zone A to
factory settings;
5: Recover all the parameters to factory settings.
(except for d group)
0: Basic menu mode
1: Fast menu mode
/ ○
2: Menu mode of non-leave-factory setting value
function codes;
3: Menu mode of last changed 10 function codes;
0: no encoder feedback vector control 1;
4: no encoder feedback vector control 2;
/ ×
8: There is encoder feedback vector control 2; (only
V6 series is valid)
Ones place:
0: Open loop digital frequency reference mode
1: AI1 analog value reference mode
/ ○
2: AI2 analog value reference mode
3: AI3 analog value reference mode
Tens palce: reserved
P0.04=0 and the frequency given in the case when
Hz ○
the multi-segment frequency terminal is invalid
0: Operation panel
/ ○
2: Communication
Function code selection
1: Terminal
15