V&T E5-H Series User Manual page 30

When using the external power supply, the external controller adopts NPN sink current wiring mode.
Note: The short circuit bar between terminal +24V and terminal PLC must be removed.
When using the external power supply, the external controller adopts PNP draw−off current wiring
mode.
Note: The short circuit bar between terminal +24V and terminal PLC must be removed.
The wiring modes of the multi−functional output terminals when the internal +24V power supply of the
inverter and external power supply are used
Note: When this wiring mode is adopted, if Y1 terminal is damaged, the polarity of the external diode must
be checked to ensure the correctness.
E5−H High Performance Universal Inverter
Chapter 3 Wiring of Inverter
User Manual
23