V&T E5-H Series User Manual page 113

P5.00 ～ P5.04
P7.00
P7.02
If the input terminal function is set to 32 (forced wake up input function). When the inverter is in sleeping
status, if close the terminal (terminal function be set to 32), the inverter will out of sleeping and enter PID
regulation process.
If the output terminal function is set to 32 (sleeping instruction). When the inverter is in sleeping status, the
terminal which function number be set to 32 is enabled.
If need to use terminal to switch close loop control and open loop control, the input terminal function
number should be set to 51.
Setting other PID parameters in P8 group, for details, refer to group P8 parameters discription.
6.19 User−defined Function Code Displayed/hidden Zone Parameters
(Group A0)
A0.00 Password of displayed/hidden zone of user-defined function code
A0.01
A0.02
Customize function code menu by function code of group A0. Protect the customized menu with
password A0.00.Only function code groups with corresponding Bit set to 1 by A0.01 or A0.02 can be
shown.
Note:
Factory default for password of displayed/hidden zone of user−defined function code is 1.
LSB (the least significant bit) to MSB (the most significant bit) of A0.01 correspond to P0, P1, P2,
P3, P4, P5, P6, P7, P8, P9, PA, Pb, PC, Pd, PE and d0 in turn.
LSB to MSB of A0.02 correspond to d1, d2 and reserved 14 bits in total.
Zones of PE, C, U0 and U1 are reserved for parameters by manufacturer.
When recovery practices of function code P0.01=4 or 5, the displayed/hidden function will be
reset back to factory default.
106
E5−H High Performance Universal Inverter
X1 to X4 terminal input function selection
Y1 terminal output function selection
Relay terminal output function selection
Displayed/hidden function 1 of user-defined function code
Displayed/hidden function 2 of user-defined function code
Chapter 6 Parameter Description
User Manual
0 ～ 99 （ 99 ）
0 ～ 47 （ 0 ）
0 ～ 47 （ 14 ）
0~FFFF(1)
0~FFFF(FFFF)
0~FFFF(FFFF)