V&T E5-H Series User Manual page 20

Figure 2−9 Removal of cover
Mounting of operation panel
Please refer to 2.3.1 Removal and mounting of operation panel.
Note:
Do not directly mount the cover with operation panel on the inverter, otherwise, the operation panel will
have poor contact.
2.3.4 Open and Close of Doors of E5−H−4T90G and Above Power Class Inverter with
Sheet−metal Enclosure
Opening of the door
Press the latch following direction 1 in Figure 2−11 and open the door following direction 2.
Removal of operation panel
The operation panel is connected to the control board through the standard network cable and will not
interfere with the open/close of the door. To remove the operation panel, refer to section 2.3.1 Removal
and Mounting of Operation Panel
Mounting of cover
After connecting the cables of main circuit terminals and control circuit terminals, close the door
following direction 1 in Figure 2−12, and then press down the latch following direction 2 to lock the door.
Figure 2−11 Opening the door
E5−H High Performance Universal Inverter
Chapter 2 Inverter Installation
User Manual
Figure 2−10 Mounting of cover
Figure 2−12 Closing the door
13